Step 1: Activate your account to access the Converge Platform
To activate your online account and login to the Converge Platform, you will receive an email from us with a link to create your password and get logged in. Please make sure that your password is longer than 8 characters and includes a mix of upper and lower case characters and symbols. Don’t delay as the link in the email will expire soon.
If you haven’t received this email or the link to set up your account expired, please follow the instructions in this link: Give access to a new user to the platform?
Once logged in, you can easily contact the support team using the blue icon in the bottom right of your dashboard, by opening a new ticket or by emailing help@converge.io.
Step 2: Setup the Converge Hardware
Now you have set up your login to the Converge platform it’s time to set up your sensors, repeaters, and nodes on-site, to start collecting data on your upcoming pour.
Hub setup:
Position: | Cental, high and in an open place |
Power: | 110V |
Range: | 30 to 50 m (Depending on the site layout) |
Technology: | 3G/4G |
Led colors: | Flashing green: Looking for network |
Stable green: Connected to network | |
Your hub relies upon having access to 110V or 230V mains power and mobile phone signal to transmit data back to the cloud. We recommend your hub is located somewhere with a clear view of the sky, that has good mobile reception.
We have found on the tower crane can be a good location, but not too high, mobile phone reception gets worse above the 40th floor.
Repeater setup:
Position: | In between the hub and nodes |
How to activate: | Press the red button 3 times in quick succession |
Battery life: | 2 to 3 months while on |
Range: | 20 to 40 m (Depending on the site layout) |
Led colors: | Blue: Stand by |
Red: Not connected to the hub | |
Green: Connected to the hub | |
RGB: Low battery | |
Install repeaters to boost the signal of nodes, each repeater should have line of sight back to the node(s) it is getting data from.
Where multiple repeaters are needed, each one needs to be within 30m of the previous one. Because repeaters are always on, their battery life is around 6-8wks so keep an eye on their battery level and swap them out where necessary.
Node Setup:
Position: | Close to the pour, where the sensor is installed |
How to activate: | Plugin the sensor in the Weipu connector in the node |
Battery life: | ~1 year |
Range: | 20 to 40 m (Depending on the site layout) |
Led colors: | Blue: Stand by |
Red: Not connected to the hub or repeaters | |
Green: Connected | |
You'll need to locate your nodes close to where you wish to take measurements. The sensor cables are 3m long and 10m extensions are available for extra flexibility.
We recommend placing nodes up out of the way, off the floor, to avoid damage during the pour.
Comments
0 comments
Article is closed for comments.