Calculating Compressive Strength
Now that you have registered your sensors on the Converge platform you are ready to start collecting data and getting real time compressive strength calculations from the system.
When you are ready to start collecting data go to the Converge Platform and select the sensor you would like to start collecting data from. This will open the sensor management page:
Now select ‘calculate’ on the right hand side to open the mix selection and pour time screen.
From this screen you will select the mix you are using and also when the concrete was poured or will be poured onto the sensor.
If you select ‘Yes’ because you have already poured the concrete previously the page will load with the current date and time. It is essential that you click on the date and time to open a date and time picker to set the actual time that the pour occurred.
Once you have selected your mix design and selected the pour time (and updated as needed) you can click on ‘ok’ to go to the next step.
You will now come to the confirmation screen, make sure to check that the time and date for the pour is correct and that you have chosen the correct mix and then click on ‘Yes that’s correct’ to start the calculation. If the information is not correct then click on ‘No, that’s not right’ and re-enter the data.